Protractor turntable

Please check the tonearm database for the mounting distance of your arm before using this protractor. Also note that Technics arms do not use baerwald alignment as standar . The Protractor Tool ensures proper cartridge alignment for optimal sound. Features mirror surface with printed directions on back.

Instructions: Mount the cartridge onto the headshell by the bolts provide leaving it loose for later adjustment. Connect the wires as per the colours marked.

Home is where my turntable is and everyone should have a two point protractor. In Use: The trick is to have the cartridge mounted so that the needle aligns perfectly on BOTH dots without moving the protractor. There are just too many templates and tractors in the market.

When you purchase our Best Tractor, we will first confirm the tonearm and turntable particulars with you. Then the Tractor is prepared using high-tech computer graphics. I knew baerwald protractors , Loefgren protractors , what is that Stevenson protractor. TT and tonearm is very close to the 60.

A more advanced step of setup in addition to basic weight and antiskate.

Only good if your turntable has a half. Alignment Protractor : Slip the hole of the Shure alignment protractor over the turntable spindle, and place the protractor on the record over the area where the stylus tracks. Inner (near the center of the record) Alignment Point: Lower the tone arm so that the stylus tip rests on the inner STYLUS TIP marking on the protractor. Below are some downloadable PDF arc protractors , used to align a cartridge to various standard null radii. Be sure to choose a protractor that matches your arm or turntable , as the accuracy of these protractors relies on the pivot to spindle distance being correct.

If you choose to use a different protractor , it is important to select one that is suitable for the effective length of the tonearm on your turntable. For the AT- LP120-USB turntable , the effective length is 230. Setting up your cartridge overhang should be easy.

We designed our protractor to make it a snap! Just place the acrylic protractor on your spindle, aim the arrow at the center of the pivot point of your arm and then adjust your arm or cartridge to align the needle with the cross hairs of the target for the . I am using an AT-PL1turntable and am attempting to install a new Denon DL- 1cartridge on it. My question is about aligning this cartridge. Turntable Phono Cartridge Stylus Alignment Protractor Tool.

Seeing as I possess close to zero knowledge about cartridge installation, I thought it would be smart to use one of these stupid protractors found at: . Manufactured from an aPVC composite so you can draw your own tracking points for custom alignments Single sided Instructions included Phonograph LP . With the cartridge mounte use a Stevenson Protractor to align the cartridge. You can print the protractor here (courtesy of vinylengine.com). If you have our newer OAtonearm, then you can align using Stevenson, Lofgren A (i.e.

Baerwald), or Lofgren B geometries.

Cardas Frequency Sweep and Burn In Record. SME 3Alignment Protractor. Easy to follow instructions included!